Peugeot 308 Key Fob Replacement
Peugeot's 308 might be catching on a bit however, it's still eye-catching. It's not the most luxurious car in its class It's the Ford Focus or Volkswagen Golf will shield you from imperfections on the road - however, it's a comfortable and a civilized drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is constant or intermittent the following suggestions should help.
Water Damage
If you leave your fob in the midst of a puddle or get it wet when kayaking, swimming, canoeing, rafting, or canyoning, it's likely to be damaged by water. Keep your key fob in a dry, dry bag each time you go outside or engage in activities that could expose it to excessive water.
You should also ensure that the fob is completely dry before opening it up and re-using it. If you detect any smells coming from the fob, such as an industrial-type smell or a sour taste like windshield washer fluid, this is another indication that it's submerged in water.
A circuit board that's wet can cause the battery to lose its charge or even explode. If you can pull your keyfob 308 out of the water it is best to turn the button side up and shake as much water as possible before opening the casing. Take the battery out, and then wipe the circuit board down with a cotton swab, which is dipped in 90 percent alcohol.
Other reasons why your Peugeot 308 remote keyless entry system could fail to function include an empty coin battery or receiver module issue, signal interference, or an electronic chip that is defective. If none of these is the problem, you can try resetting the system by disconnecting the battery that is 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start feature that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to entering. This feature is extremely beneficial, especially during cold winter months. Remote start systems can be stopped for a variety of reasons, such as a dead coin-battery.
A coin-shaped battery that is in the key fob will last a time of between two and four years, based on how often it's used and the location where it was purchased. The date for use-by will be printed on the package or in the user manual.
If the key fob has stopped functioning after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip completely before replacing it. If the key fob was exposed to salty or soapy water, it may have caused the chip to be damaged. You'll need to replace it.
If you're unsure if the battery is defective you can check its voltage using a multimeter attached to both the terminals plus and minus. The voltage should range from 12-13 volts but if it is lower, the battery should be replaced. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should then start after this.
Faulty Receiver Module
If you don't see "Key Detected" message, it could mean that your receiver module is faulty. It's the component that sends an indication to the car when your key fob is activated, it also acts as an immobiliser and prevents it from starting until the correct key is used.
This could result from a variety of factors including water damage or simply ageing. If the electronic chip within your Peugeot 308 keyfob is damaged by dirty tap water It could be because the keyfob was contaminated with it. In this instance, you'll have to remove it and thoroughly clean it with isopropyl or an electronic cleaner. When the battery is dry you can try it again.
If peugeot spare key persists the issue persists, it's a good idea to visit an area Peugeot specialist or locksmith. They will be able to employ a diagnostic tool help pinpoint the issue and repair it for you.
The loss of your Peugeot keys to your car is an extremely stressful experience. However, a trained auto locksmith can resolve the issue in just a few minutes. They can program your vehicle and cut a new functioning key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The chip inside the Peugeot 308 key fob is an important part of the remote control system. If the chip is damaged, you could have problems starting your car or receive a message that says "anti-theft". In this scenario the only option is to replace the key. Auto locksmiths who are professionals can provide this service in the shortest time.
The chip in the chip of your Peugeot 308 key fob can be damaged by water damage, sweat dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, you should clean it immediately. You can wipe the electronic component with an absorbent paper towel that has been soaked in isopropyl Alcohol. After that, allow the battery to dry completely.
Sometimes, a key fob can cease to function due to radio interference. This is usually caused by other devices operate on the same frequency as your Peugeot keyfob. This could be due to unsafe conditions or objects that are near to the vehicle. It is recommended that you visit a Peugeot dealer if you have this problem.
The Peugeot Key Fob 207/308 is very delicate and requires special care. It is imperative not to throw or drop the key fob. If you lose something, try to find it as quickly as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.